We have cut out a part of the design from the Ornaments model template, to make it easier to repeat the motif several times on the surface.
The stenciling technique is very simple, you just have to fix the template to the surface that we are going to decorate. Then, apply the paint with the special brush for Stencil, depositing a small amount with the brush perpendicular to the surface, managing to define the drawing precisely.
As soon as we finish applying the paint, we remove the Stencil and let it dry.
The insole can be washed to be reused as many times as you want thanks to its resistant material.
To make a more extensive texture, repeat the stenciling technique over the entire surface that we want to decorate, matching a line of the drawing already made with the template.
Once the paint is dry, we apply varnish Finish Glass to protect and add a crystalline finish of high hardness and shine.
To apply the varnish Finish Glass, mix in a disposable plastic or glass container, one part of component B Hardener, with two of component A Resin, stir well.
Protect the edges of the work with masking tape so that the varnish Finish Glass it does not overflow from the sides and thus achieve a layer of the desired thickness.
Pour carefully over the entire surface, the tape acts as a barrier so that the product does not pass through and also achieve the desired thickness. The product can be poured in the center since one of its qualities is that it self-levels when resting on a flat horizontal surface.
Let dry for 48 or 72 hours, depending on the thickness of the layer and the room temperature. If you want a thickness greater than 5mm, it is advisable to do it in two layers with intermediate drying. Once dry, we can sand the edges of the piece to leave the surface smooth and uniform.
